";s:4:"text";s:3289:" The Apollo XPander Optical Smoke Detector and Mounting Base (XPA-CB-12034-APO) is recommended for use as general purpose Smoke Detectors for early warning of fire in most installations. Enhanced reliability of smoke detection with PureLight® technology Simple installation with a new easy-fit base and an isolator located in the head Compatible with CoreProtocol, XP95 & Discovery protocols The Series 65 Standard Relay Base provides one set of volt-free, changeover (form C) contacts that change state when the detector signals an alarm. The Apollo XPA-CB-12034-APO operates on the well-established light scatter principle. To restore the detector to quiescent condition, it is necessary to expel any smoke and interrupt the electrical supply to the detector for a minimum of one second. The Smoke Detectors from Apollo are designed to detect smoke around the Detector. Fully compatible with C-TEC's XFP & ZFP XP95/Discovery Addressable Fire Panels. Apollo Fire Detectors and Base Range. Works using the light scatter principle and responds well to slow-burning, smouldering fires. Apollo Fire Detectors and Base Range. Works using the light scatter principle. The optical design of this Apollo Smoke Detector allows it to respond to a wide spectrum of fires. User programmable to operate in one of five sensivity modes (e.g.
Fully compatible with C-TEC's XFP & ZFP XP95/Discovery Addressable Fire Panels. In clear air conditions the photo-diode in the XP95 detector receives no light from the LED and produces a corresponding analogue signal. Apollo offers several types of detector for specialist applications, including Duct Detectors, Flame Detectors, Beam Detectors and Aspirating Smoke Detectors.
Mode 1 will give a higher senstivity to fire than Mode 5). Alarmsense by Apollo is a range of detectors, sounders and accessories designed to be connected to a single cable, saving time and money whilst simplifying the whole installation process. The detector changes to alarm state at a pre-set threshold of smoke penetration into the sensing chamber.
These are all designed for very specific circumstances covering commercial heating and ventilation ducts, dirtier environments where flaming fires may be expected, and protection of large, open spaces. The Series 65 Optical Smoke Detector complies with the essential requirements of the EMC Directive 2014/30/EU, provided that it is used as described. The signal increases when smoke enters the chamber and light is scattered onto the photo-diode. Alarmsense by Apollo is a range of detectors, sounders and accessories designed to be connected to a single cable, saving time and money whilst simplifying the whole installation process. Comprehensive range of Apollo Conventional / Non-Addressable Optical Smoke, Apollo Heat Detectors and Apollo Multi-criteria Smoke and Heat Detectors.